Each Efusion DUO comes with carbon fibre and wood veneer panels.Abalone panels can be purchased separately.
Lost Vape Efusion DUO DNA200/133 Box Mod comes with the dual 18650 sled
pre-installed inside. The LiPo pack is optional!
The Efusion DUO by Lost Vape is the first fully customisable DNA200 device on the market, giving vapers the ability to use both dual 18650s and 1300mAh 3S lipo configurations. The mod comes with a dual 18650 battery sled fitted inside and ready to use, with pre-soldered terminal leads & mounting screws. While the DNA200 initially required an 11.1V nominal input, Evolv is pushing out a firmware update that will allow the chip to operate in a reduced-voltage mode, thereby permitting the use of two 18650 batteries in serial configuration In order to compensate for the drop in peak voltage, the wattage ceiling will be reduced from 200W to 133W.
While all of the other DNA200 devices currently available are already locked in permanently to inaccessible, internal 3S LiPo batteries, regardless of any software upgrades to the chip. With our Efusion DUO, now vapers can choose whatever vaping styles they like. If you prefer the convenience of 18650s and do not require higher that 133W, then this is the device for you. If you however decide to get the full force of the board, then do not worry, we have you covered on that too. Just remove the pre-installed sled inside, and install the LiPo pack(optional). After that, its a simple set up in Escribe, and you should be good to go in no time.
The box is precision, CNC machined out of the good old 6063-T6 aluminum, polished and bright dip anodized finish, to give the mod a glossy-shinny fresh look. Again, the mod features removable and replaceable panels, available in Carbon Fibre, variety of wood material, New Zealand Abalone, leather ect.
Featuring a stainless steel ball bearing sliding lock back panel, changing the battery has never been so easy. You can charge both your 18650s or 3S lipo pack in-device via the micro USB with Evolv's built in balanced charger which keeps all cells balanced while charging, but also you can charge your 18650 batteries externally via a battery charger.
Powered by Evolv DNA200 temperature protection board
With Evolv's Escribe software, dial in your perfect vape with over 93 options
Compatible with both Dual 18650s and 1300mAh lipo pack
Utilizing XT30 and JST connector for maximum compatibility and user serviceability
Temperature Limit: 200°F - 600°F
Output power using dual 18650s: 1Watt - 133Watts
Output power using 3S Lipo: 1Watt - 200Watts
Precision CNC machined of 6063-T6 aluminum body
Polished and bright dip anodized glossy finish
Stainless steel 510 atomizer connector
Stainless steel ball bearing sliding lock battery door
Ultra responsive custom milled stainless steel buttons
Spring loaded nickel plated brass center pin
Integrated 1Amp micro-USB on-board balanced charger (cord included)
Pass-thru charging functionality
Standard Cover material: Carbon Fiber (silver/black), Natural Wood Skins